ACU-RITE 200S READOUTS Manual do Utilizador descarregar pdf (Página 80)

66 II

II - 1 Installation Setup

The Position Recall feature, when it is “ON”, will store the last

position of each axis when power was turned off, and then redisplay

that position once power is turned back on.

Diagnostics

The DIAGNOSTICS provides access for testing the keypad, and

edge finders.

Keypad Test

An image of the keypad provides an indication when a switch is

pressed, and released.

8 Press each hard, and soft key to test. A dot will appear on each key

when it has been pressed indicating that it is operating properly.

8 Press the C key two times to exit the keypad test.

Edge Finder Test

8 To test the edge finder, touch the edge finder to a part. An * will

appear on the display screen above the corresponding edge finder

in use. Grounding type edge finder symbol is to the left, and an

electronic edge finder symbol is to the right.

Display Test

8 To test the display, press the ENTER key to cycle through the

available colors.

Note that any movement that occurs while power is off will

be lost. Whenever power has been off it is recommended

to re-establish workpiece datums using the Reference

Mark Evaluation procedure.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 97 98

Sem comentários

ACU-RITE 200S READOUTS Manual do Utilizador Página 80