Acu-rite VUE Manual do Utilizador descarregar pdf (Página 19)

I – 1 Introduction to VUE

Job Setup Parameters

U To view, and change Job Setup parameters, first press the SETUP

soft key.

U Use the UP/DOWN arrow keys to highlight the parameters of

interest.

U press the Enter key.

Units

The Units form is used to specify the preferred display units, and

format. The unit of measure can also be selected by pressing the

INCH/MM soft key in either Actual Value, or Distance-To-Go mode.

Scale Factor

The scale factor may be used to scale the part up, or down. A scale

factor of 1.0 creates a part with the exact size as dimensioned on the

print. A scale factor >1 “grows” the part, and <1 “shrinks” the part.

U The numeric keys are used to enter a number greater than zero. The

number range is 0.1000 to 10.000. A negative value may also be

entered.

U The scale factor settings will be retained on a power cycle.

U When the scale factor is a value other than 1, the scaling symbol

is shown on the axis display.

U The ON/OFF soft key is used to disable the current scale factors.

Mirror

A scale factor of -1.00 will produce a mirror image of the

part. A part can be both mirror, and scaled at the same

time.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 57 58

Sem comentários

Acu-rite VUE Manual do Utilizador Página 19